Although the XP's seat is very comfortable, on longer rides I always start to touch one of the seats' back rails with my back bones. Very uncomfortable to say the least. Tightening the mesh was limited due to the construction of it, which in my case ment that when even tightened at maximum, my back still touched the rail.
On the Ransbike discussion forum I've read about the Sling Mesh Seat, which is a comparable seat but has a different mesh with long straps to tighten. It is not mentioned on the ShopRans pages (but there's a picture of it on here), but is available anyway for $400. Since I'm not sure if the seat fits my 2005 Stratus and the additional shipping costs + taxes would make it very expensive, I don't consider this to be an option.
I posted my problem on the forum and one of its members suggested to install some rubber pipe isolation on the seat rails and then put the seat mesh back on over the isolation. Sounded great, so yesterday I went to a home improvement superstore and bought a piece of plastic isolation hose. Cut it open in length, installed it on the seat rails and put the seat mesh back on. It now has more room to strengthen the straps, which should allow me to tighten the mesh some more and prevent my back bones from touching the seats' rail. Pretty easy solution, why didn't I think of it myself ?
As usual, only time will tell if my seat problem is solved or not, but I'm pretty sure that it is.
Plastic isolation hose on both seat rails does the trick ....
No comments:
Post a Comment